Remote Control - Faber GLOW WH GLOSS KL Manuel

5. REMOTE CONTROL

This appliance can be commanded using
a remote control, powered by a CR2032
type 3 V battery (not supplied).
• Do not place the remote control near
heat sources.
• Do not discard the batteries with normal
waste, they must be put into the specific
containers.
Turns the motor On and Off.
-
Turns the lights On/Off.
Press and hold the button for about 2 seconds to turn the light on / off secondary.
Enables/Disables the motor at INTENSIVE speed from any other speed, even if the motor is
turned off. This speed is timed to run for 6 minutes. At the end of this time, the system returns
automatically to the speed that was set before. If it is activated with the motor turned off, it will
switch to Off at the end of the time. It is disabled by pressing the button again or pressing the
"Motor Off" button.
Press and hold this button for a few seconds to activate total shutdown of the hood (lights +
motor) after 30 minutes.
To deactivate the DELAY, simply press the button again or turn the suction motor off. The
DELAY is indicated on the keyboard by flashing of the motor LED (every 0.5 seconds).
Press and hold the button for 2 seconds to activate the 24h function. The hood turns on at
speed 1.
In this case the suction motor is turned on for 10 minutes every hour for a total of 24h, after
which the function is deactivated automatically. The 24h function is indicated on the keyboard
by flashing of the motor LED (every 2 seconds). To deactivate the 24h function, simply press
the button again or turn the suction motor off. Function not enabled with Intensive or Delay
active.
Increases the working speed of the motor.
Decreases the working speed of the motor.
6. LIGHTING
• For replacement contact technical sup-
port ("To purchase contact technical
support").
6