SPORTSTECH RX600 Manuel D'utilisateur page 38

HEART
P，30~240
RATE
HEART
ON/OFF blink
SYMBOL
MANUAL
PROGRAM P1~P12
5 ~ 90 ±1SPM
RACE
0.1 ~99.9±0.1
KM(ML)
USER U1~U4
55%、75%、90%、
H.R.C.
IND
(TARGET)
SCAN
TIME/500M 0:00 ~ 99:59
STROKES 0 ~ 9999
TOTAL
0 ~ 9999
STROKES
2. OPERATION DESCRIPTION
1. Make sure plug in right power adaptor (12V 1500mA), and regarding with different country system pin, and then
powering on: BI with long tone for 1 second together with LCD full display for 2 seconds,
2. Powering on (or hold RESET key for 2 seconds) full display. Press START/STOP key entering MANUAL control mode
directly and start exercise..
3. USER display in dot matrix to choose (U1-U4), you can turning knob UP +, DOWN －for choice USER number and
input USER data after pressing ENTER for confirmation. Press ENTER-key for confirmation if everything, it will step to
upper key functions, all blink and wait for USER, turn KNOB UP +, DOWN －KNOB for choice, it will jump back to
UX(0-4) choice). ※ USER
4. ENTER "CONTROL MODE"- MANUAL / PROGRAMS / USERS / H.R.C./ RACE
4-1 Manual
LOAD1 and display in dot matrix after pressing ENTER key for confirmation, now turn KNOB UP +, DOWN －
knob for adjusting LOAD value and ENTER key for confirmation, turn UP +, DOWN －KNOB again for setting,
Press START and begin to exercise after finish all functions' setting (I.e. TIME 、 DISTANCE 、 CALORIES 、 HEART
RATE).
4-2 PROGRAM
0→30~240 Y
N N
1~16 LEVEL
Y
(±1LEVEL)
1~12 Y
Y
55%、75%、
Y
90%、IND
(TARGET)
N N
N N
0 ~ 9990±10 Y
N Y
: U0 ~U4 ( U1 ~ U4 memorized user data; U0- No memory of data and workout value)
Y i.e. calculating forum D
1. Display with blink as per Heart Rate Hi / Fast &
N Low slow.
2. No Heart-Rate detected SYMBOL will be gone.
N Set up Resistance-Load from Level 1-16
1. P1～P12，12 fixed diagram.
2. Every time you choose one PROGRAM,
correspondent diagram will display on the center
of dot matrix..
3.Diagram choice by turning UP、DOWN-Knob，and
N
ENTER
4.After selecting program, blinking diagram will
show in dot matrix, turning UP/DOWN-KNOB for
adjusting LEVEL and ENTER
TIME setting，TIME symbol blinks.
USER can set SPM of PC as well as distance for
race.
1.USER can set PROGRAM diagram by himself
2.press ENTER
N
UP、DOWN Knob for adjusting LOAD value.
3. One saved value each.
1. choice your want H.R.: 55%、75%、90%、IND.
2. (55%、75%、90%、IND) symbol blink during
N
setting, constant light after choosing and then
step to time setting, TIME symbol blinks.
1.TIME&TIME/500M。
2. & CALORIES switch to display every 6 seconds.
N
3. DISTANCE switch to display every 6 seconds.
4. STROKES &TOTAL STRORES switch to
display every 6 seconds.
Y
Y STROKES ALARM one
Y
for confirmation.
-KEY for
KEY for line setting and