Polar GJ447 Mode D'emploi page 4

UK
Installation
Note: If the unit has not been
stored or moved in an upright
position, let it stand upright for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging and
the protective film from all surfaces.
2. Avoid positioning the appliance in direct
sunlight or damp areas.
3. Maintain a distance of 20cm (7 inches)
between the unit and walls or other objects for
ventilation. NEVER LOCATE NEXT TO OR
NEAR A HEAT SOURCE.
4. Insert the slide-out shelf/shelves at the desired
levels.
5. If necessary, adjust the screw feet of the
appliance to make it level.
Note: Before using the appliance
for the first time, clean the
shelves and interior with soapy
water.
Operation
Control Panel
The control panel is located below the doors on the
front of the appliance.
Defrost Light Cooling Light
4
GJ447-GJ448-GJ449_ML_A5_v2_20200402.indb 4
Turn On
1. Close the door(s) of the appliance.
2. Connect the appliance to a mains power
supply.
Note: The Cooling Light is
illuminated when the appliance
is chilling the interior cabinet.
To Change the Operating
Temperature
The default operating temperature is 2 °C. To
display the operating temperature (set point),
press and immediately release the button.
To change the operating temperature:
1. Press and Hold the SET button for 2 seconds.
"°C" will start to flash.
2. Press the or buttons to change the
temperature.
3. Press the SET button to store the temperature.
Manual Defrost
• POLAR Back Bar Chillers feature an automatic
defrost. However, should the appliance require
an additional defrost period press and hold the
button for 2 seconds.
• Automatic defrost cycles are every 6 hours and
last 20 minutes (factory defaults).
Note: If a manual defrost is
started this resets the automatic
defrost timer. During defrost
periods the Defrost light is
illuminated.
Cleaning, Care &
Maintenance
• Switch off and disconnect from the power
supply before cleaning.
• Clean the interior of the appliance as often as
possible.
• Do not use abrasive cleaning agents. These
can leave harmful residues.
• Always wipe dry after cleaning.
• A POLAR agent or qualified technician must
carry out repairs if required.
2020/4/2 10:11