Fcc Statement - HoMedics SP-129HJ Manuel D'instructions

INSTRUCTIONS FOR USE
Plug the receptacle end into the input jack located near the side of the massager and plug included
adapter into a 120-volt AC outlet.
Shiatsu and Vibration Body Massager is very versatile and designed for use on the neck, back, and
shoulders. However, you may find it works well for other body areas as well. See pages 6-7
for instructions on how to use the hand control.
CAUTION: To avoid pinching, do not lean on the shiatsu massage mechanism in the pillow when
adjusting your body position.
Do not jam or force any part of your body in the moving massage mechanism.
NOTE: Only gentle force should be exerted against the unit in order to eliminate any/all risk of injury. You
may soften massage force by placing a towel between yourself and the unit.
4
MAINTENANCE
TO CLEAN
Unplug the unit and allow it to cool before cleaning. Spot clean only with a soft, slightly damp sponge.
Never allow water or any other liquids to come into contact with the unit.
• DO NOT immerse in any liquid to clean.
• Never use abrasive cleaners, brushes, or strong chemicals that might or might not be flammable and/
or damaging to the product to clean.
• DO NOT attempt to repair the massager. There are no user-serviceable parts. For service, contact the
Consumer Relations telephone number listed in the Warranty section.
TO STORE
Place massager in its box or in a cool, dry place. Avoid contact with sharp edges or pointed objects that
might cut or puncture the fabric surface. To avoid breakage, do not wrap the power cord around the unit.
Do not hang the unit by the power cord.

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules and CAN ICES-3 (B)/NMB-3 (B). These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
5