Wireless Surround Sound Setup - Paradigm PREMIUM WIRELESS PW 300 Mode D'emploi

WIRELESS SURROUND SETUP
NOTE: A Paradigm PW Soundbar and a device with the DTS Play-Fi
app is required in order to complete this setup.
Once the PW Soundbar has been connected to your network,
proceed with the Surround Sound setup in your DTS Play-Fi app.
Start by simply tapping on the Settings icon on the main page of
the DTS Play-Fi app, then navigate to the Surround Sound option.
This will open the Settings page for Surround Sound, and since you
haven't set up DTS Play-Fi Surround Sound yet, it will prompt you to
do so by tapping on the + button down in the lower right.
10
Surround Set-Up will begin and the app will preface with some
information and instructions. Once you proceed, the app will detect
if there are products available on the network that can support
DTS Play-Fi Surround Sound, or if there are products that need an
update from the manufacturer to enable support.
The guided setup will walk you through selecting a speaker to set
the correct placement and distance (this and other settings can be
adjusted later after setup is complete). This process is the same for
all three speaker placements, but the PW Soundbar (Front position
speaker) must be designated as a DTS Play-Fi Surround Sound Master.
NOTE: The PW 300 must be connected to the wireless
network for the Wireless Surround Setup procedure. If your
PW 300 is wired to your network, disconnect the Ethernet cable
and connect it wirelessly to your wireless network.