Vacuuming Dry Materials; Vacuuming Liquids - RIDGID WD06700 Manuel Du Propriétaire

To reduce the risk of electric shock, this
appliance has a polarized plug (one
blade is wider than the other). This plug
will fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit,
contact a qualified electrician to install the
proper outlet. Do not change the plug in
any way.
After you plug the power cord into the outlet,
turn the unit on by pushing the switch from
position "O" to position "l". The symbols
used on the switch actuator are international
"On & Off" symbols. "O" is the symbol for
"OFF" and "l" is the symbol for "ON".
= OFF
Familiarize yourself with the accessories
included with the vac. Each accessory may
be used in various ways for vacuuming
and blowing debris. Here is a list of the
accessories and their uses.
Utility Nozzle - General purpose nozzle for
most vacuuming applications.
Wet Nozzle (9 gallon models only) -
Used for wet pickup on smooth surfaces
to pick up liquid and dry the surface in
one stroke.
Extension Wands - These wands can be
connected together and provide
additional length.
Hose - Provides transfer of vacuum or
blowing capability to work site. Provides
the means of attaching extension wands
and nozzles.

Vacuuming Dry Materials

1. The filter must always be in correct
2. When using your vac to pick up fine
NOTE: A dry filter is necessary to pick up
dry material. If you use your vac to pick
up material when the filter is wet, the filter
will clog quickly and be very difficult to
clean.
3. If your filter is wet but you need to use
= ON

Vacuuming Liquids

1. When picking up small amounts of
2. When picking up large amounts of
3. When the liquid in the drum reaches a
4. After using the vac to pick up liquids, the
9
position at all times to avoid leaks and
possible damage to vac.
dust, it will be necessary for you to
empty the drum and clean the filter at
more frequent intervals to maintain
peak vac performance.
the vac to pick up dry material, you
must first allow the filter to dry.
liquid the filter may be left in place.
liquid it is recommended that the filter
be removed. If the filter is not removed,
it will become saturated and misting
may appear in the exhaust.
predetermined level, the float
mechanism will rise automatically to cut
off air-flow. You will know that the float
has risen because suction stops and the
motor noise will become higher in pitch,
due to increased motor speed.
When this happens, turn off the vac,
unplug the power cord, and empty the
drum.
filter must be dried to avoid possible
mildew and damage to the filter.