Klarstein 10031557 Mode D'emploi page 19

Installation
1 For optimum viewing, mark the top four screws fixing positions on wall in
accordance with the recommend fixing dimensions (see Fig.2). Drill holes with a six
drill bit.
2 Fix the wall bracket using that the plug and screws provided .
3 Carefully lift the heater up ensuring that the top rear ledge of heater engages the
wall bracket (see Fig.2 in circle) and is sitting centrally.
4 Lift softly towards the wall.
5 Mark the bottom holes position (see Fig.3), remove the heater ensuring that the
bottom fixing bracket is rotated up.
6 Drill and fit wall plug.
7 Refit the heater to the wall fixing bracket and rotate the bottom fixing bracket down
again and use the screw provided to permanently fix the heater in place.
8 Unpack the pebbles from the bag and place them along the light unit in the desired
position.
1
3
2
EN
19