Care And Maintenance - Whirlpool WMT 503 Mode D'emploi

60202056.book Page 16 Friday, October 21, 2011 4:32 PM

CARE AND MAINTENANCE

Prolonged disuse
1. Empty the refrigerator.
2. Disconnect the appliance from the power supply.
3. Defrost and clean the interior.
4. In the event of prolonged disuse, leave the door open to
prevent the formation of mould, odours and oxidation.
5. Clean the appliance.
• Clean the inside of the low temperature compartment (where
fitted) when defrosting.
• Periodically clean the inside of the refrigerator compartment
with a sponge dampened in warm water and/or neutral
detergent. Rinse and dry with a soft cloth. Do not use abrasive
products.
• Clean the outside with a soft damp cloth.
Do not use abrasive products, scourers, stain-removers
(e.g. acetone, trichloroethylene) or vinegar.
Replacing bulbs:
When replacing the bulb, proceed as follows:
• Unplug the appliance from the mains.
• Remove the screw that secures the light cover.
• Squeeze the tabs on the sides of the lamp cover and remove it.
• Replace the bulb with a new one, maximum 15 W.
• Put the lamp cover back on and wait 5 minutes before plugging
the appliance back into the mains.
Clean the outside using a soft cloth.
- Clean the inside of the low temperature compartment (where
fitted) when defrosting.
- Periodically clean the inside of the refrigerator compartment
with a sponge dampened in warm water and/or neutral
detergent. Rinse and dry with a soft cloth.
Do not use abrasive products, scourers, stain-removers e.g.
acetone, trichloroethylene) or vinegar.
16