Display Off; Display Lock - Levoit Smart True HEPA Guide D'utilisation

EN
USING YOUR PURIFIER (CONT.)
Timer
You can set a timer for 1–12 hours.
1. Tap . The display will switch from
showing the PM2.5 reading to the time
you've selected.
2. Tap repeatedly to select a time in
1-hour increments. If you don't touch any
buttons for 5 seconds, the display will
switch to showing the PM2.5 reading and
the timer will start automatically.
Note: Press and hold
cycle through timer options automatically in
1-hour increments.
3. The timer will count down from your
selected time.
Note:
•
While a timer is active, tapping
show the remaining time, rounded up to
the nearest hour. Tap
5 seconds to add more time in 1-hour
increments.
•
You can see the exact remaining time in
the VeSync app.
4. When the timer is finished, the air purifier
will turn off.
5. To cancel a timer, tap
the display reads "
Note:
•
You can change the fan speed at
any time while the timer is on.
•
The timer will restart if the time
is changed.
•
The air purifier will remember the
last timer setting while turned off,
but the timer will be cancelled and
need to be restarted.
•
You can set a timer for 1–24 hours
in the VeSync app.
10
for 2 seconds to
will
again within
repeatedly until
--H
".

Display Off

This turns off the display lights on the air
purifier, including button lights and indicator
lights (except the Check Filter Indicator).
1. Tap to turn off the display.
2. Tap any button (except
temporarily turn the display back on. If
you don't tap another button, the display
will turn back off after 3 seconds.
3. Tap to turn the display back on. The
display will stay on.
Note: The Check Filter Indicator will still turn
on and stay on if it's time to check your filter
(see page 14).

Display Lock

When the air purifier is on, you can lock
the display to prevent settings from being
accidentally changed. Buttons will not
respond to being tapped.
1. Press and hold
the display. The
in the centre of the display.
Note: If the display is turned off, the
indicator will flash 3 times to show that the
display has been locked, then turn off.
2. The indicator will blink when any
other button is tapped to indicate that
Display Lock is on.
3. Tap and hold
to unlock the display. The
will turn off.
Note:
•
If the display is turned off, the
indicator will flash 3 times to show that
the display has been unlocked.
•
Display Lock can still be used when the
air purifier is in Standby Mode.
or ) to
for 3 seconds to lock
indicator will light up
again for 3 seconds
indicator