Mopar 82208995 Notice D'installation page 8

F. Locate the White/Brown wire in pin
#1 of the 10-way connector, found
at the headlight switch. Center-
splice the harness White/Brown
wire into this wire, following the
center-splice prodedure on page 7.
G. Route the three remaining wires
(Black/White, Dk Green and Dk
Blue) through the cowl panel and
into the engine compartment.
H. Using the supplied butt connector,
connect the Black/White wire to
the remaining wire from the hood
safety switch.
I. Remove the plastic engine cover (if
equipped) by lifting upwards. Route
the Dk Blue wire to the top of the
engine at the coil connection point
as shown. Center-splice the Dk
Blue wire to the Dk Blue/yellow
wire at the coil, following the
center-splice procedure on page 7.
Solder the connection.
J. Route the Dk Green wire to the relay
junction box on the passenger side of
the engine compartment. Remove
the horn relay as shown in the
diagram. Slide the supplied relay
terminal connector over terminal 85 of
the relay as shown in the diagram.
Re-insert the relay into place. Route
the wiring from the relay connector
out of the junction box and connect to
the Dk Green wire using the supplied
butt connector.
8