Mopar 82208995 Notice D'installation page 9

K. Connect the 24-way and 10-way
connectors into the PC-12 Remote
Start module. Also, connect the 2-
way antenna connector (on end
opposite the main harness connec-
tions).
4. Install SKREEM Interface Module.
A. Following the directions on the
supplied ampule of adhesive
primer, apply a thin coating of
primer to the entire SKREEM
transceiver antenna coil. Allow the
primer to dry for 5 minutes before
proceeding to the next step. Note:
Use goggles and gloves to
protect yourself from any acci-
dental contact.
B. Remove backing from one side of
the supplied two-way tape and
apply tape around the transceiver
antenna coil.
C. Route the antenna loop from the
SKREEM Interface module to the
ignition cylinder.
D. Remove the remaining backing on
the tape and position the antenna
loop on the tape around the trans-
ceiver antenna coil. Ensure the red
stripe faces out towards key. Press
down on antenna coil to ensure a
strong bond.
E. Using a supplied wire tie, secure
the antenna coil as shown.
Antenna
24-Way 10-Way
9