Leggett & Platt Okin 20 Guide D'utilisation page 6

If the adjustable base fails to operate, investigate the symptoms and possible solutions provided in the
chart below:
SYMPTOM
No features of the base will activate.
Remote control backlight does not illuminate.
Head or foot section will elevate, but will not return
to the horizontal (flat) position.
Excessive motor noise.
6
TROUBLESHOOTING
SOLUTION
• Program the remote control (see Remote Control
Programming section of this manual for programming
procedures).
• Unplug power cord, wait 30 seconds and plug in to reset
electronic components.
• Electrical circuit breaker may be tripped. Check electrical
service breaker box to verify.
• Defective surge protection device or electrical outlet. Test
outlet by plugging in another working appliance.
• If the base was operated over the rated duty cycle, thermal
switch opens. Wait 30 minutes before trying to operate the
base. Once the base resumes normal operation, do not exceed
the duty cycle.
• Replace batteries in remote control.
• Base mechanism may be obstructed. Elevate base and check
for obstruction. Remove obstruction.
• Head section may be too close to the wall.
• If base is located on hard surface flooring, place carpet pieces
or rubber caster cups under each leg or caster of the base.
• Elevate the head or foot section a short distance (with the
remote control) to realign the lift/lower mechanisms with the
base support platform.
• Verify that base is not positioned against a wall, nightstand, or
other object that may cause vibration or noise.
• If base is installed over a base frame, verify motors are not
causing base frame (or base frame components) to vibrate.