Leggett & Platt Okin 20 Guide D'utilisation page 3

PRESS & HOLD TO ONE TOUCH
Note: If using 2 remotes to operate 1 or more bases, both remotes must be set to the same "press & hold" or "one touch" mode.
To change remote control functions from "press and hold" to "one touch" ("one touch" = press and release), simultaneously touch the HEAD MASSAGE DOWN and
FOOT MASSAGE DOWN buttons for 5 seconds. The massage motor and underbed light will turn on and off confirming the change. Your base is now set to "one touch."
When in "one touch" mode:
M1, M2, M3, Z Grav, and Snore buttons
Press and release (one touch) button. Base will adjust to the programmed position. Press any other button to stop the base during movement.
Flat button
Press and release (one touch) button. Base will shut off massage motor, if active, and adjust base to level position. Press any other button to stop the base during
movement.
To revert back to factory settings, simultaneously press and hold the SET button and the FLAT button for 5 seconds. The massage motor will turn on and off
confirming the change. Your base is now set to factory settings.
REMOTE CONTROL PROGRAMMING - 1 REMOTE TO OPERATE 1 BASE
STEP 1
UNPLUG base from power source. Wait 3 minutes,
then PLUG base back in.
STEP 2
Simultaneously press and hold both the HEAD UP and
FLAT buttons on the remote control (FIGURE 1) until
the backlight on the remote flashes once, then release
the buttons.
FIGURE 1
HEAD UP
BUTTON
HEAD
HEAD
M1
M3
STEP 3
Press any button on the remote control to verify the base
functions correctly.
SNORE
FOOT
ZGRAV
ON/OFF
FOOT
SET M2
FLAT
FLAT BUTTON
SNORE
HEAD FOOT
ZGRAV
ON/OFF
HEAD FOOT
M1 SET M2
M3 FLAT
3