Remote Control Function - Leggett & Platt Okin 20 Guide D'utilisation

Press and hold to raise the head section.
Press and hold to lower the head section.
UNDERBED LIGHT BUTTON
Press to turn underbed light ON or OFF.
MASSAGE ON/OFF BUTTON
Press to turn massage motors ON or OFF
HEAD MASSAGE INCREASE (+) BUTTON
Press to increase massage intensity. Massage
has 3 speeds: Low, medium and high. Massage
will automatically shut off after 15 minutes.
HEAD MASSAGE DECREASE (-) BUTTON
Press to decrease massage intensity. Massage
has 3 speeds: Low, medium and high. Massage
will automatically shut off after 15 minutes.
Press and hold to adjust base to the programmed
position. To program a position, adjust base to
desired position, press and hold the set button
until the massage motors and underbed light turn
on and off, then press and hold the M1 button
until the massage motors turn on and off.
Press and hold to adjust base to the programmed
position. To program a position, adjust base to
desired position, press and hold the set button
until the massage motors and underbed light turn
on and off, then press and hold the M3 button
until the massage motors turn on and off.
Used to program M1, M2, M3, Z Grav, and Snore
Press and hold to lower the base to the level position.
REMOTE CONTROL REQUIRES (3) AAA SIZE BATTERIES. TO CONSERVE BATTERY LIFE, THE
TRANSMITTER TURNS OFF ALL FUNCTIONS WHEN ANY BUTTON IS PRESSED FOR MORE THAN
2

REMOTE CONTROL FUNCTION

HEAD UP BUTTON
HEAD DOWN BUTTON
.
M1 BUTTON
M3 BUTTON
SET BUTTON
presets.
FLAT BUTTON
LOCK BUTTON
To lock / unlock the remote control
buttons, press and hold lock button for
5 seconds. Backlight will flash 3 times.
SNORE
HEAD FOOT
ZGRAV
ON/OFF
HEAD FOOT
M1 SET M2
M3 FLAT
NOTE
50 SECONDS.
SNORE BUTTON
Press and hold to raise head to the preprogrammed
position. Head will automatically lower to flat after
15 minutes. To program a position, adjust base to
desired position, press and hold the set button until
the massage motors and underbed light turn on
and off, then press and hold the Snore button until
the massage motors turn on and off.
FOOT UP BUTTON
Press and hold to raise the foot section.
FOOT DOWN BUTTON
Press and hold to lower the foot section.
FLASHLIGHT BUTTON
Press and hold to turn the flashlight ON.
Release the button to turn the flashlight OFF.
Z GRAV BUTTON
Press and hold to adjust base to the
preprogrammed position. To program a position,
adjust base to desired position, press and hold the
set button until the massage motors and underbed
light turn on and off, then press and hold the Z
Grav button until the massage motors turn on and
off.
FOOT MASSAGE INCREASE (+) BUTTON
Press to increase massage intensity. Massage has
3 speeds: Low, medium and high. Massage will
automatically shut off after 15 minutes.
FOOT MASSAGE DECREASE (-) BUTTON
Press to decrease massage intensity. Massage has
3 speeds: Low, medium and high. Massage will
automatically shut off after 15 minutes.
WAVE BUTTON
Press to turn massage on in wave mode.
Press again to cycle through wave speeds.
M2 BUTTON
Press and hold to adjust base to the programmed
position. To program a position, adjust base to
desired position, press and hold the set button until
the massage motors and underbed light turn on
and off, then press and hold the M2 button until the
massage motors turn on and off.