Leggett & Platt Okin 20 Guide D'utilisation page 4

REMOTE CONTROL PROGRAMMING - 1 OR 2 REMOTES TO OPERATE 2 BASES
STEP 1
Press and hold FLAT and SET buttons on remote(s) until
backlight flashes once, then release both buttons.
STEP 2
UNPLUG both bases.
STEP 3
Place both bases on their sides close to each other
(FIGURE 2).
CAUTION: DUE TO RISK OF INJURY, TWO ADULTS ARE
REQUIRED TO HANDLE AND MOVE ADJUSTABLE BASE.
FIGURE 2
STEP 4
Locate the sync cable (FIGURE 3).
FIGURE 3
SYNC CABLE
NOTE: SYNC CABLE
CONNECTOR ENDS ARE
COLOR CODED YELLOW.
STEP 5
UNPLUG underbed light module from control box on base
1 (FIGURE 4). Save for reinstall in Step 7.
FIGURE 4
UNDERBED
LIGHT
MODULE
4
CONTROL 1
STEP 6
Plug male end of sync cable into multifunction port on
control box of base 1 (FIGURE 5).
FIGURE 5
STEP 7
Plug underbed module into female end of sync cable
(FIGURE 6).
FEMALE ENDS
(YELLOW)
FIGURE 6
MALE ENDS
(YELLOW)
FEMALE
END OF
SYNC
CABLE
CONTROL
BOX BASE 1
STEP 8
Repeat Steps 5-7 with control box on base 2.
STEP 9
Turn bases back over on their legs. Plug both bases back
into power source. Bases should now be in sync.
SNORE SNORE
HEAD FOOT HEAD FOOT
ZGRAV ZGRAV
ON/OFF ON/OFF
HEAD FOOT HEAD FOOT
M1 SET M2 M1 SET M2
M3 FLAT M3 FLAT
REMOTE REMOTE
CONTROL 2
MULTIFUNCTION PORT
MALE END OF
SYNC CABLE
YELLOW
UNDERBED
LIGHT MODULE
BASE 1
BASE 2
CONTROL BOX
BASE 1
CONTROL BOX
BASE 1