Leggett & Platt Okin 20 Guide D'utilisation page 5

Use this procedure to lower the base to flat during a power outage. Do NOT put
batteries in power down device until necessary for use.
Note: Power down device uses 9-volt alkaline batteries, which are not included.
STEP 1
Unplug base from electrical source.
STEP 2
Insert (2) 9-volt alkaline batteries into the power brick (FIGURE 7).
FIGURE 7
UNDERSIDE OF
POWER BRICK
STEP 3
Press the FLAT BUTTON on the remote control until each section is flat (FIGURE 8).
FIGURE 8
HEAD
HEAD
M1
M3
STEP 4
Remove batteries from power brick and discard. Note: Batteries are good for only
one use.
When power is restored from outage, plug base into power source. Base is ready
to resume normal operation.
POWER DOWN OPERATION
INSTALL (2) 9 VOLT BATTERIES
*BATTERIES NOT INCLUDED
SNORE
FOOT
ZGRAV
ON/OFF
FOOT
SET M2
FLAT
FLAT BUTTON
BATTERY
COMPARTMENT
DOOR (push in
and slide up to
remove)
5