Periods Of Non-Operation; Troubleshooting - Electrolux GT292 Notice D'utilisation

58 www.electrolux.com
The best time to defrost the freezer when
it contains no or only a little food.
1. Switch off the appliance.
2. Remove any stored food, wrap it in
several layers of newspaper and put
it in a cool place.
3. Leave the lid open , remove the plug
from the defrost water drain and
collect all defrost water on a tray.
Use a scraper to remove ice quickly.
4. When defrosting is completed, dry
the interior thoroughly and refit the
plug.
5. Switch on the appliance.
6. Set the temperature regulator to
obtain the maximum coldness and
run the appliance for two or three
hours using this setting.
7. Reload the previously removed food
into the compartment.

8. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
8.1 What to do if...
Problem
The appliance does not
operate.
The appliance is noisy.
Audible or visual alarm is
on.
Power indicator light is
flashing.

7.3 Periods of non-operation

When the appliance is not in use for long
periods, take the following precautions:
1. Switch off the appliance and
2. Remove all food
3. Defrost and clean the appliance and
4. Leave the lid open to prevent
Possible cause
The appliance is switched
off.
The mains plug is not con‐
nected to the mains socket
correctly.
There is no voltage in the
mains socket.
The appliance is not sup‐
ported properly.
The cabinet has been re‐
cently switched on or the
temperature in the appli‐
ance is too high.
An error has occurred in
measuring the temperature
or the appliance is not
working properly.
disconnect the appliance from
electricity supply.
all accessories.
unpleasant smells.
If the cabinet will be kept on,
ask somebody to check it
once in a while to prevent
the food inside from spoiling
in case of a power failure.
Solution
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect to a different elec‐
trical mains socket. Con‐
tact a qualified electrician.
Check if the appliance
stands stable.
Refer to "High Tempera‐
ture Alarm" and if the prob‐
lem still occurs contact the
nearest Authorized Service
Centre.
Contact the nearest Au‐
thorized Service Centre.