Troubleshooting - Volpi KVS8000P Manuel De L'utilisateur

20. Troubleshooting

Make sure that the tool is repaired only by qualified people from our service centers, using only original
parts as spare parts.
This will ensure the life and the safety of the tool.
Problem
La chainsaw does not
work
Intermittent operation
Chain heated
Bad cutting surface
It does not charge. Red
light of the charger flashes
Possible cause
Low battery
Battery disconnected
Switch malfunction
Loose internal connections
Switch malfunction
Ruined chain
Poor lubrication
Damaged bar
There is no lubrication, resulting in
excessive friction
Ruined chain
The cut result is poor
The battery is not fully charged
The battery is not inserted
correctly in the battery charger
connector
The charger is not properly
connected to the power socket
Dirty battery poles
Damaged battery
Damaged Battery charger
Corrective action
Charge the battery
Connect the battery
Send to the service center
Send to the service center
Replace the chain
Check the lubrication
Replace the bar
Check the lubrication
Replace the chain
Read carefully the user's manual
Charge the battery
Insert the connector correctly
Connect it properly
Clean the poles
Replace the battery
Replace the battery charger
51