Early Working Procedures - Volpi KVS8000P Manuel De L'utilisateur

• To adjust the length of the pole, loosen the adjustment ring nut
• Pull out the extension to the desired size and hold it in place
• Tighten the pole adjustment ring nut until it is locked.
• To adjust the head tilting, turn the head locking ring nut anti-clockwise.
• Tilt the head to the desired position
• Turn the head locking ring nut clockwise until it locks.

13. Early working procedures

Wear suitable gloves and clothing before using this tool. Check the tool before working
and verify the correct operation of the switch. The chain must stop when the trigger is
released. Do not use the chainsaw if the switch fails. Check that the battery voltage
matches the tool voltage.
The engine stops when the trigger is released, but the chain will continue moving by inertia
for a few seconds. Do not touch the chain while it is moving to avoid the risk of injury or
wounds.
42