Assembly/Disassembly - Pride Mobility Products LIFT CHAIR Serie Manuel Du Propriétaire

I V . A S S E M B L Y / D I S A S S E M B L Y
Your lift chair may require some assembly before initial use. It may also require disassembly to make
servicing the chair more convenient. If your lift chair is a Knock-Down (KD) model, follow the instructions
in "Lift Chair Setup."
CHAIR BACK ASSEMBLY
NOTE: If your lift chair is an Infinite model, refer to the assembly instructions provided with the chair.
For the 2-position model, the KD sleeves are located on the inside as shown in figure 4.1.
2-POSITION MODEL
BARIATRIC MODEL
INFINITE MODEL
Figure 4.1 Lift Chair Assembly
1. Check that the locking clip on the back of the chair is in the vertical position. Reposition if necessary.
2. Drape the hand control and cable over the chair base, then slide the back onto the base. Ensure the
hand control cable is routed through the rear of the lift chair.
NOTE: Depending on chair width, you may need to slide on one side of the back at a time. If this is the
case, level the chair-back before pressing down to lock into position.
10
3-POSITION MODEL
WALL HUGGER MODEL
PROPER CLIP POSITION
HOOK AND LOOP FLAP
Lift Chair Series