Basic Troubleshooting - Pride MID-SIZE SCOOTER Serie Manuel Du Propriétaire

V I I . B A S I C T R O U B L E S H O O T I N G
Any electromechanical device occasionally requires some troubleshooting. However, most of the problems that
may arise can usually be solved with a bit of thought and common sense. Many of these problems occur because
the batteries are not fully charged or because the batteries are worn down and can no longer hold a charge.
DIAGNOSTIC BEEP CODES
The diagnostic beep codes for your scooter are designed to help you perform basic troubleshooting quickly and
easily. A diagnostic beep code will sound in the event one of the conditions listed below develops. Depending on
the model you own, your scooter will communicate by one of the coding methods as follows:
1. A beep code will begin with a series of fast beeps directly followed by slower beeps which indicates the actual
code. The beep code is only beeped once. To repeat the beep code, remove the key, then reinsert it and turn it
to the "on" position, OR
2. A beep code will identify the condition, pause, then repeat the beep code. The beep code will continue to alert
you in this manner until the scooter is turned off.
NOTE: Your scooter will not run unless the beep code condition is resolved and the scooter has been turned
off, then turned back on.
BEEP CODE
■
(1)
■■
(2)
■■■
(3)
■■■■
(4)
■■■■■
(5)
■■■■■■
(6)
■■■■■■■
(7)
■■■■■■■■
(8)
■■■■■■■■■
(9)
Figure 28. Models with Tiller Console
34
CONDITION
Battery charge is too low to operate the scooter. Charge batteries as soon as possible.
Battery charge is too low.
The scooter's battery voltage is too high to
operate the scooter, or the charger is still
connected to the off-board charger port.
Current limit time out.
The manual freewheel lever is in the freewheel
position.
Throttle control lever not at center position at
start up.
Speed pot error.
Motor volts error.
Other internal errors.
SOLUTION
Charge batteries.
Unplug charger and/or turn key off, then back
on again.
Turn the scooter off for a few minutes, then turn
your scooter back on.
Remove the key from the key switch, then push
the manual freewheel lever to the drive position
and restart your scooter.
Verify that the batteries are fully charged. If
the batteries are fully charged, then return the
throttle control lever to center position, turn
scooter off then back on.
Contact your authorized Provider for assistance.
Contact your authorized Provider for assistance.
Contact your authorized Provider for assistance.
Mid-size Scooter Series