Campingaz Fargo TwinPack Utilisation Et Entretien page 9

C - INSTALLING THE CAMPINGAZ
CARTRIDGES
(Where the existing cartridge is empty, read paragraph
G: "REMOVING A CV 470 PLUS CARTRIDGE").
When installing or changing a cartridge, always operate
in a very well-ventilated location, preferably outside,
never near a flame, heat source or spark (cigarette,
electric apparatus, etc.) and far away from other people
and inflammable materials.
AS CAMPINGAZ ® CV 470 PLUS CARTRIDGES ARE
VALVE-OPERATED, THEY CAN BE DETACHED FROM
THE EQUIPMENT, EASILY TRANSPORTED (EVEN
WHEN NOT EMPTY) AND FITTED TO OTHER
CAMPINGAZ ® EQUIPMENT IN THE 470 PLUS RANGE
DESIGNED TO OPERATE EXCLUSIVELY WITH
THESE CARTRIDGES.
The device operates using two CV 470 Plus cylinders.
- Check that gas input is properly closed by placing the
"a" adjustment lever to OFF and by turning the
TwinPack "b" regulator in a clockwise direction until it
stops. Close the regulators tightly to ensure proper gas
shut-off.
- Remove the TwinPack from the support located behind
the device.
- Check the "J" sealing rings (see figure below) before
assembling a new gas recipient.
- Be sure that the "J" sealing rings located on the
TwinPack are in place and in proper condition before
attaching gas recipients. Do not use a device that has
damaged or worn seals.
- Holding the TwinPack, gently screw a cylinder onto the
device by turning it in a clockwise direction until you
hear a "click" (approximately one-sixth of a turn). Do not
force when screwing the cylinder: you may damage the
cylinder valve.
® CV 470 PLUS
Regulator
- Repeat this operation for the second cylinder.
- Place the TwinPack with its two cylinders behind the
device, about 10 centimeters from the vat.
The Fargo TM TwinPack is ready for use.
In the event of leakage (smell of gas prior to turning the tap
on), take the equipment outside immediately, in a well-
ventilated area with no combustion source, where the leak
can be located and halted. If you wish to check that your
equipment is correctly sealed, do so outside. Never attempt
to locate leaks using a flame. Use gas leak solution.
D - LIGHTING THE BURNER
D-1 Prior to use
Never use the barbecue until the instructions have been
read carefully and understood. Also, make certain that:
- two CV 470 Plus cylinders are connected
- there are no leaks
- the venturi tubes are not blocked
- the hose does not touch any components which may
get hot.
- that the feet are unfold (see paragraph B-2).
D-2 Piezo ignition of the burner
1. Open the TwinPack regulator valve by turning the "b"
adjustment knob in a counter-clockwise direction.
2. Push on the "a" adjustment lever of the device and
turn it to the full-flow position ( ), then push
immediately on the "p" ignition button (
hear a click. Repeat 3 or 4 times if necessary until the
burner is lit.
9
GB
10 cm
) until you