Power Fist 8000365 Guide D'utilisation page 5

shown) before connecting the machine to the power supply.
6. Always keep the cord from contacting moving parts of the
machine.
7. Do not apply side pressure to the saw blade. It can break.
8. Do not saw tiles that are too small to lead through.
9. Put the saw blade protector over the saw blade after use.
10. Disconnect from power supply before you open the machine.
Immediately switch off the saw in any of the following cases:
1. Malfunction of the plug, receptacle or damage to power supply
cord.
2. Broken switch.
3. Smoke or odor caused by scorched insulation.
Before Operating the Saw
1. Choose the correct saw blade for the material to be cut. Use only a
diamond saw blade with a minimum diameter of 6" and a
maximum diameter of 7". The arbor hole must be 7/8".
2. Important! Fill the water reservoir.
Be sure that the water reservoir is filled completely so that the saw
blade turns trough enough water. This is necessary to cool the saw
blade correctly.
Maintenance
Caution! While maintaining and cleaning the machine, disconnect
the power supply cord from the receptacle. Never use water or other
corrosive liquids to clean electrical parts of the machine. Periodic
maintenance of cutting machine will prevent unnecessary problems.
Keep the ventilation slots of the cutting machine clean to prevent
overheating of the motor.
Troubleshooting
Below is a list of possible problems and corresponding actions:
1. The motor becomes hot.
The cooling ventilation slots in the motor are blocked with dirt.
Clean the cooling ventilation slots.