emerio VCE-108278.11 Mode D'emploi page 8

Please note:
The Hepa filter in the cleaner will become dusty over time. This is normal and will not affect the performance of
the filter. If the Hepa filter is so dusty that suction does not return to 100%, we suggest that the filter be removed
then rinsed under the faucet and allowed to dry for 24 hours by airing not near the fire or some high temperature
objects before refitting into the vacuum. This should be done once six months or when suction power appears
to be reduced obviously.
Important: Please note that there is a safety switch inside the vacuum to prevent the unit from being run with
high vacuum rate. If the vacuum is too high, the safety switch will be turned on. In this case, it can minimize the
vacuum rate and protect the motor from being broken.
Note:
The suction hole must be open, free of any obstructions at all times. Otherwise, the motor will overheat and
could become damaged.
If the suction power of the vacuum cleaner gets low please check the hose for obstacles. You can open the hose
by pressing the square part on the hose handle. Take apart the two parts and remove any obstacles. To assemble
the hose again first press the flexible hose into the handle and then click in the connection part.
Important:
All filters should be checked regularly for signs of damage, preferably after each cleaning task. The filters must
be replaced immediately if they become damaged. Always disconnect the vacuum from the electrical outlet
when checking the filters.
Parking:
This vacuum cleaner can be parked as below style to save your room space.
- 7 -