Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Setting higher output levels than the one obtained through the AUTO-
SCAN could reduce the quality of the received signals.
Manual programming
FM/BI INPUT
FM/BI OUTPUT VOLTAGE
FM/BI GAIN
Adjustable from 0 to 30 dB
Wait for the AUTO-SCAN procedure to end, which
depends on the number of channels received from the
antennas.
When the AUTO-SCAN procedure is completed the
display will show the output level depending on the
number of channels automatically saved. Press
confirm and complete the procedure. To change the output
▲▼
level press the keys
If required, it is possible to adjust the output slope. Select
SLP and press
to confirm, select the slope of the slope
by pressing the ▲▼ keys and press
To start the manual programming, position the pointer
▲
on MAN through the
Press
to enter the menu to set the FM/BI input
parameters.
Press
to start the pointer
▲▼
to select ON or OFF to enable the remote power
supply on this input. Press
The remote power suppy is set on 24V. It can be changed
to 12V in the ADVANCED menu.
Position the function selector
start the pointer
to scroll options, select the desired
output level through the keys
- 16 -
then press
to confirm.
to confirm.
key and press
to continue.
to scroll options then press
to confirm.
on GAIN and press
▲▼
and press
to
to
to confirm.
Publicité
Table des Matières
