Keys And Display - Aprimatic Programmateur Instructions Pour L'installation

The Programmer is an electronic device used for programming control equipment, which
may be connected with a quick-fit connector present on the printed circuit card.
This device allows the installer to carry out all the adjustments and settings required
during installation or setting-up, without having to adjust the trimmers and DIP-switches.
Once programming is completed, the programmer must be disconnected from the card.

1.1 KEYS AND DISPLAY

The programmer consists of 5 keys and 1 four-digit display, as shown in the diagram:
a) 2 "ARROW" keys used to select the function or the parameter to be modified (← back
→ forward)
b) 2 increment and decrement keys for setting the value required (+ and -)
c) a central ENTER key for confirming the setting, which saves the value in a memory
(EEPROM) present on the control card. The value remains saved even if there is a
power failure.
The 4-digit display shows the following values:
• 2 right-side digits: value of the parameter
• 2 left-side digits: identification number for the parameter/function to be modified
Example: if the display indicates 13 50, it means that the "Pause time" parameter has
been selected (identification number 13) and this parameter is currently set at 50% (50)
of the maximum value permitted for this type of operator.
2 Left-side digits:
function or
parameter selected
Display
Confirms the data
set or selected
"BACK" arrow key
2 right-sided digits:
value of the
parameter selected
or the setting
Increment key
"FORWARD"
arrow key
Decrement key
PROGR.EPS