Aprimatic Programmateur Instructions Pour L'installation page 10

GENERAL PROGRAMMING TABLE
Adjustments
Wing opening delay (swing gates only)
Wing closing delay (swing gates only)
Approach/Slow-down speed
Pause time
Work time
Brake enabling delay (sliding gates only)
Anti-crush device adjustment
Partial opening span (sliding gates only)
Available for future functions
Available for future functions
Available for future functions
Available for future functions
Available for future functions
Available for future functions
Available for future functions
Operating modes
Automatic
Special automatic
Super automatic
Diagnostics
Open/Close semiautomatic
Semiautomatic with stop
Semiautomatic with reverse
Dead man
Traffic lights
Available for future functions
Function Parameter
code value
Opening pre-flashing: ON (1) or OFF (0)
10 0-20
Closing pre-flashing: ON (1) or OFF (0)
11 0-20
Release stroke (swing gates): ON (1) or OFF (0)
12 0-15(*)
Reverse at end of cycle (up-and-over garage doors):
13 1-90(*)
ON (1) or OFF (0)
14 1-90(*)
Automatic START (0) or manual START (1) with
15 0-20
additional safety device not triggered
16 0-99
Slow-down base: 8 (0) or 19 (1) semi-waves
17 0-32
Anti-crush management: thrust limiter (0) or STOP (1)
18 0-99
Additional safety photocell enabled: STOP (0) or STOP
+ brief reverse movement (1)
19 /
Photocells: standard (0) or with reset (1)
20 /
Anti-crush enabling: ON (1) or OFF (0)
21 /
No start with standard safety function triggered: ON (1)
22 /
or OFF (0)
23 /
Available for future functions
24 /
(*) The values of parameters 12, 13 and 14 for the T4-P are, respectively, 0-99, 1-80
Function Parameter
code value
25 0
Functions 98 and 99 are used to transfer all the settings and the adjustments from the
25 1
programmer to the control card and vice versa.
25 2
25 3
25 4
25 5 These two functions are very useful when there are two or more identical systems. It is
possible to program only one system and then transfer all the data to the other systems
25 6
with a simple operation.
25 7
To apply this function, hold down ENTER for at least 5 seconds.
25 8
25 9
Operating modes
and 1-90.
Data transfer from an operator to the programmer
Data transfer from the programmer to the operator
Function Parameter
code value
35 0/1
36 0/1
37 0/1
38 0/1
39 0/1
40 0/1
41 0/1
42 0/1
43 0/1
44 0/1
45 0/1
46-50 /
98
99