Aprimatic Programmateur Instructions Pour L'installation page 9

USER INSTRUCTIONS
Caution - The product may only be used by the skilled technical personnel of the
assistance and/or assembly service.
Caution - The programmer connector can only be inserted in one direction. If you
have to force it in, check that the direction is correct.
2.1 CARD CONNECTION PROCEDURE
Caution - Before connecting the programmer, make sure that the control card is not
powered up.
1. Connect the programmer to the control card, inserting the mobile connector into the
fixed connector on the control card. To identify the position of the fixed connector on
the control card, refer to the instructions for the device.
2. Power up the system.
3. The programmer is supplied with power by means of the connection with the control
card. If there are no problems, the display must be lit.
2.2 PARAMETER/FUNCTION SETTING PROCEDURE
NOTE - If the programmer is not used for 10 seconds while connected to the control
card, the display goes OFF. Press any key to turn it ON again.
1. Use the ARROW keys to select the function or the parameter you want to set or
modify, checking the identification number on the two left-side digits
below).
2. When you have selected the parameter or function required, use the + and – keys to
change the value and read the value on the two right-side digits
3. Press ENTER to confirm the value set.
4. In the event of an error or if you need to change the value again, repeat the procedure
from point 1.
5. When you have finished all the settings or adjustments, disconnect the power supply
and disconnect the programmer from the control card. Do NOT pull the cable.
NOTE - Currently, there are several "free" functions/parameters (from 51 to 97). During
the search stage, they are skipped by the programmer.
This section includes the tables which the installer must use for programming the control
equipment.
NOTE - The operating modes, functions and settings listed in the programming tables
are described in detail in the instructions for the professional electronic
equipment.
FUNCTIONS TABLE
The functions from 00 to 06 are very useful during installation to check the correct
setting of the operator. They simulate the enabling of the following inputs:
(see table
(see table below).
Example:
1) use the "arrow" keys to select function 01 - Single wing start - and check the identification
number on the two left-side digits .
2) press ENTER.
3) one wing of the swing gate will open.
Open/Start
Single wing start
Stop
Close
Partial opening start
Standard safety function (photocell 1)
Additional safety function (photocell 2)
Available for future functions
Available for future functions
Available for future functions
00
01
02
03
04
05
06
07
08
09