Cleaning; Storage; Troubleshooting; Replacement Filter - Workshop WS0250VA0 Mode D'emploi

Cleaning

To keep your Wet/Dry Vac looking its
best, clean the outside with a cloth
dampened with warm water and mild
soap.
To clean the drum:
1. Dump debris out.
2. Wash drum thoroughly with warm
water and mild soap.
3. Wipe out with dry cloth.
Problem
Vac will not pick up dirt
Vac will not run
WARNING: If any of the power head assembly parts should become
detached or broken, exposing motor or any other electrical components,
operation should be discontinued immediately to avoid personal injury or
further damage to the Vacuum. This Vacuum has no user serviceable parts.
Replacement filters are available where
you purchased your Vac and on
www.WORKSHOPvacs.com. The part
number is WS01025F.
MAINTENANCE (continued)

TROUBLESHOOTING

1. Clogged filter
2. Clogged hose
3. Air leak
1. No electricity

REPLACEMENT FILTER

Storage

Before storing your Vac, the dust drum
should be emptied and cleaned. The cord
should be wrapped around the unit and
the hose should be stored as described
in the cord/hose storage section in this
manual. Accessories should be kept in
the same area as the Vac so they can be
readily available. The Vac should be
stored indoors.
Cause
11
Remedy
1. Clean or replace filter
(follow instructions on
page 10)
2. Remove hose and
clear debris.
3. Make sure power
head is securely
attached to dust drum.
1. Make sure electrical
outlet has voltage.
(A qualified electrician
may need to be
contacted).