Frequently Asked Questions - Fantec MM-HDRL Manuel Utilisateur

AUDIO PERFORMANCE
DA Converter
AD Converter
Signal-Noise (1kHZ)
Dynamic Range
(1kHZ)
Channel
Separation
Total Harmonic
Distortion (1kHZ)
GENERAL
Power Supply
Power
Consumption
Operating
Temperature
Operating Humidity
Hard Disk
Dimensions
(W/H/D)
Net Weight
Note: The specifications and design of this product are subject to change without notice.

13.2 Frequently Asked Questions

Question 1. My computer does not recognize my player.
Answer:
(1) Make sure the player is powered on. If it is off, the computer will not be able to find the
player;
(2) Make sure the player is connected to computer. (Refer to 1.4.1 for connecting player to
computer);
(3) When using Windows 98SE, install the USB driver first. After installation, restart the
computer. Then reconnect the player to the computer. (Refer to 1.4.1 for connecting player to
computer);
(4) If you installed the Windows 98SE driver over your Windows® XP, 2000, or ME edition,
problems might occur;
(5) It is not recommend using the USB ports in the front of your computer, try to use the USB
ports in the rear, because the USB ports in the front are often from non-powered hubs.
Question 2. When I try to disconnect the USB device, I keep on getting "The device
24-bit/192kHZ
24-bit/96kHZ
≥ 95dB
≥90dB
≥95dB
≤-85dB
AC 100~240V
Approx. 35 W
+5°C to +35°C (+36°F to +95°F)
5% to 80% RH
3.5'' SATA HDD
61x198x171mm
Approx 1.5 kg
50~60Hz
EN 133 / 214