Appendixes; Specifications - Fantec MM-HDRL Manuel Utilisateur

Step 2: Connect the USB Pen Drive
Plug the USB Pen Drive into one of the USB HOST ports of the player.
Step 3: Hold the POWER/STANDBY button
Press and hold the POWER/STANDBY button on the front panel, and do not loosen.
Plug the power cable into the DC IN jack, wait for about 3 seconds or more, and then loosen
your finger on the POWER/STANDBY button.
Firmware installation will start in about 30 seconds. The LED indicators on the front panel will
be enlightened and flashing during installation. If it is connected to a TV set, a yellow install
page will appear on the TV screen.
Please wait for about 2 minutes, the installation will be completed, the LED indicators will go off,
and the player will be powered off automatically. Then you can press the POWER button to
turn on the player and enjoy.
Note:
Do not turn off the power during installation;
The USB Pen Drive is not allowed to be unplugged during installation.

13. Appendixes

13.1 Specifications

USB SUPPORTED:
USB HDD
Other USB Mass Storage Devices
USB 2.0 Interface
EN 131 / 214