Specifications - Rockford Fosgate POWER 1000 Installation Et Fonctionnement

S
PECIFICATIONS
MODEL
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts
Front and Rear Channels
4 Load Per Channel
2 Load Per Channel
1 Load Per Channel
4 Load Bridged
2 Load Bridged
Sub Channel
4 Load Per Channel
2 Load Per Channel
1 Load Per Channel
Dimensions: Height
Width
Length
Amplifier Fuse Rating (Amp/Type)
Battery Fuse Rating (Amp) External (Not Supplied)
Signal-to-Noise Ratio
Crossover Slope (Front and Rear Channels)
Crossover Slope (Sub Channel)
Crossover Frequency (Front and Rear) (Multiplier x1)
Crossover Frequency (Front and Rear) (Multiplier x10)
Crossover Frequency (Sub Channel) (Low Pass Only)
Frequency Response (Front and Rear)
Frequency Response (Sub Channel)
Bandwidth
Slew Rate
IM Distortion (IHF)
Signal Voltage Adjustment Range
Protection
Equalization (Variable Punch Bass)
Input Impedance
Infrasonic Filter (Sub Channel)
These specifications are Amplifier Power Standard CEA-2006 Compliant
Specifications subject to change without notice
14
POWER 1000
>80dB A-weighted @ 2Vrms
Selectable 12dB/octave Butterworth or
24dB/octave Linkwitz-Riley
12dB/octave Butterworth
variable from 40Hz to 400Hz
variable from 400Hz to 4000Hz
variable from 32Hz to 250Hz
20Hz to 20kHz ±0.5dB
20Hz to 250Hz -3dB
20Hz to 200kHz ±3dB
Variable from 150mV to 4V (RCA Input)
NOMAD - Internal analog-computer output protection circuitry
limits power in case of overload, plus short protection.
Thermal switch shuts down the amplifier in case of overheating.
Variable from 0dB to +18dB @ variable 35 to 70Hz
Selectable 12dB/Octave, -3dB @ 28Hz
50 Watts x 4
100 Watts x 4
150 Watts x 4
200 Watts x 2
300 Watts x 2
300 Watts x 1
600 Watts x 1
800 Watts x 1
2.6" (6.60cm)
12.8" (32.51cm)
23" (58.42cm)
(1) 250A / ANL
250A
30 Volts/µS
<0.05%
10k ohms