A
CCESSORIES
PUNCH Capacitors
Maintain the power you need to your Punch Amplifier.
PUNCH Install Kits
A variety of install kits are available to help you install your Punch amplifier like a professional.
Para-Punch Remote Bass Control
This adds an adjustable center frequency control with the adjustable boost control.
See our web site for other accessories to help you get the most out of your system.
www.rockfordfosgate.com
S
PECIFICATIONS
MODEL- PUNCH
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts
4
Load Mono
2
Load Mono
Dimensions:
Height
Width
Length
Amplifier Fuse Rating (Amp/Type)
Battery Fuse Rating (Amp) External
(Not Supplied)
Signal-to-Noise Ratio
Crossover Slope
Crossover Frequency (P325.1)
Crossover Frequency (P600.1 bd)
Frequency Response (P325.1)
Frequency Response (P600.1 bd)
Bandwidth (P325.1)
Slew Rate
IM Distortion (IHF)
Signal Voltage Adjustment Range
Protection (P325.1)
Protection (P600.1 bd)
Equalization (45Hz Punch Bass)
Input Impedance
Infrasonic Filter (P600.1 bd)
These specifications are Amplifier Power Standard CEA-2006 Compliant
Specifications subject to change without notice
12
P325.1
175 Watts x 1
325 Watts x 1
2.1" (5.33cm)
11" (27.94cm)
11.7" (29.72cm)
(1) 40A / ATC
40A
>80dB A-weighted @ 2Vrms
12dB/octave Butterworth
variable from 40Hz to 400Hz
variable LP (low pass) from 35Hz to 250Hz
20Hz to 20kHz ±0.5dB
20Hz to 250Hz ±3dB
20Hz to 200kHz ±3dB
Variable from 150mV to 4V (RCA Input)
NOMAD - Internal analog-computer output protection
circuitry limits power in case of overload, plus short
protection.Thermal switch shuts down the amplifier
in case of overheating.
Short circuit protection shut downs the amplifier in
case of very low impedance or shorted speaker wires.
Thermal switch shuts down the amplifier in case of overheating.
Variable from 0dB to +18dB @ 45Hz
Selectable 12dB/Octave, -3dB @ 28Hz
P600.1 bd
325 Watts x 1
600 Watts x 1
2.1" (5.33cm)
11" (27.94cm)
13.7" (34.80cm)
(2) 30A / ATC
60A
30 Volts/µS
<0.05%
10k ohms