Rockford Fosgate POWER 1000 Installation Et Fonctionnement page 8

I
NSTALLATION
9. Connect the speakers. Strip the speaker wires 1/2" and insert into the speaker terminal and tighten
the set screw to secure into place. Be sure to maintain proper speaker polarity. DO NOT chassis
ground any of the speaker leads as unstable operation may result.
10. Perform a final check of the completed system wiring to ensure that all connections are accurate.
Check all power and ground connections for frayed wires and loose connections which could cause
problems. Install inline fuse near battery connection.
NOTE:Follow the diagrams for proper signal polarity.
CAUTION:These amplifiers are not recommended for impedance loads below 1
stereo and 2
Mono
Bridged
• RCA Inputs connect to FRONT inputs only.
• 2/4/5 CH SWITCH positioned right to set to 2 CH.
• Gain (Front, Rear & Sub) - is set independently to suit application.
• Crossover (Front, Rear & Sub) - is set independently to suit application.
8
bridged.
2-Channel Wiring