Dometic HOT PRODUCTS D21 Manuel D'installation Et D'utilisation page 6

D21 Drop-in Cooktop
4.2 Placing your cooktop
Inside installation
Screw
2
Nylon
Washer
Corner
Piece
Drilled Hole
➤ Locate and cut the opening in the countertop
according to the dimensions in "4 .1
Constructing the cabinet" on page 5 .
➤ Drill holes in the countertop to match the
location of the screw holes on the Cooktop .
➤ Place one corner piece (supplied) at each corner
of the opening, so that the lip of the corner
piece is flat against the countertop .
➤ Insert the screws and nylon washers (supplied)
to install the Cooktop .
➤ Place the Cooktop into the opening so that is
rests on top of the corner pieces . Hand-tighten
the screws to the countertop .
➤ Verify the Cooktop is level from side to side and
front to rear .
➤ Tighten the screws to secure the Cooktop to
the countertop using a #2 screwdriver . Do not
overtighten .
EN
Outside installation
3
Cooktop
Counter
Cutout
Cooktop
I
Do not store the Cooktop outside .
RV Exterior
6