Use And Operation - oneConcept CTR1 Mode D'emploi

1. When using the appliance, make sure that it is on a flat and stable surface. Damage may occur if
it is placed on an incline or decline, and put the ice box into water tank:
2. Insert the plug directly into a standard AC socket-outlet. Be sure plug fits tightly into outlet.
3. Turn the timer knob to ON position
4. Press the LO/MI/HI button to set the desired fan speed (Low/ Medium/High).
5. VANE button: If you want to enlarge blast area in your room, press the vane button, the fan will
blast your room in large scope; the vane light will be illuminated. To stop vane, just press the
vane button again, the vane pilot light will go out. Moving the horizontal louvers either up or down
can make further wind direction enhancements.
5-1. UP DOWN VANE button: Press the „ UP DOWN VANE „ button once or more, set up the outlet
starting page or stop swinging around air supply, at the same time corresponding instructions
icon light or go out.
5-2. LEFT RIGHT VANE button: Press the „ LEFT RIGHT
VANE „ button once or more, outlet yawing page star-
ting or stopping air supply bobbing up and down, and
the corresponding instructions icon light or go out.
6. TIMER button: Set the time by pressing the timer button to select a desired timing level as follow,
the range is between 0.5-9 hours. The pilot light corresponding to the selected timing level will
be illuminated.
7. MODE button: The default setting is Normal wind, and then you can press the button Mode again
to choose your desired wind mode as per the following sequence: The wind mode selecting can
be circulated and the wind mode pilot lamp will be on during the fan mode in operating.
8. COOL button: Please noted that the COOL LAMP will flashing when you press the Cool button if
there is no or lacked water in water tank.
8-1. Before operating the unit in Cool mode, make sure the escape valve for the water tank is
properly fixed. Then proceed to add clean water into the water tank. While adding the water,
make sure that you keep an eye on the water level indicator to make sure that you do not OVER
or UNDER FILL the unit. Press the button Cool after you have added the water and the unit should
commence to blow cooler air. The cool light will light on at the same time. When you press the
button Cool again, it will stop working, the cool light will also go out.

Use and Operation

9