Laserworld Diode Série Mode D'emploi page 12

Manual: Diode Series
Please note that not each pattern can be combined with each effect.
8. ILDA control:
Connect your device („ILDA IN") via an ILDA cable to an interface / controller. Use a
laser control software, e.g. Phoenix or Pangolin, to run the device. Use „ILDA OUT"
to connect it to another device.
9. To turn off the device switch it off („OFF"), switch the key to ‚OFF' and disconnect the
power cable from the mains.
Convergence settings for dichros - Service openings
Settings for convergence must be made while the laser unit is running, therefore please take
care about your safety first - Don't look directly at the laser beam!
1. There is a flap on the front panel. Unscrew the screws and carefully remove the flap.
Both dichros are right behind the flap.
2. Now you can set the color convergence using the two dichros, by carefully adjusting the
allen screws.
3. With the correct setting of the color balance ( put red, green and blue on top) you get a
perfect white.
4. After setting up, cautiously attach the flap back on the front panel of the laser unit.
page 12 / 37