Costco Agio 1902357 Mode D'emploi page 7

3. Place the tabletop upside down on a flat, non-abrasive surface. Attach two table legs to the
table top by using four 1/4"x50 mm bolts and Ø20xØ6.5x2.0mm washers as shown in Figure 4.
Guide the bolts through the holes in the table leg into the pre-drilled holes in the table top. Hand
tighten only 2-3 turns.
4. After making any necessary adjustments to the alignment of the firepit, use the hex bolt driver
to tighten all bolts. Repeat until all bolts are tight. Do not over tighten. Over tightening may strip
bolts. With the help of another person, turn the table in the upright position.
5. Place the burner pan protective ring into the firepan/burner assembly as shown in Figure 5.
Align the holes in the burner pan protective ring with the pre-drilled holes on the firepan/burner
assembly. Secure the burner pan protective ring to the firepan/burner assembly by using the two
M4 screws as shown in Figure 5.
Figure 4
Figure 5
7