Festo CPX-CP-4-FB Mode D'emploi page 13

3 Installation instructions
3.1 Assembly
The CPX-CP interface is mounted in a manifold sub-base of
the CPX terminal.
1
Screws, tightening
torque
0.9 ... 1.1 Nm
2
CPX-CP interface
3
Contact rails
4
Manifold block
(as desired, here
with additional
power supply as
an example)
Disassembly:
• Remove the screws and lift the CPX-CP interface up
carefully.
Mounting
1. Check the seal and sealing surfaces and refit the
CPX-CP interface.
2. Screws must be placed so that the self-cutting threads
can be used. Tighten the screws in diagonally opposite
sequence at first by hand (Torx T10). Tightening torque
0.9 ... 1.1 Nm.
Festo CPX-CP-4-FB-Z6 1212a English
1
2
3
4
13