Grant GD100 Instructions D'utilisation page 6

2.2.1.1 Accessory cooling
Where Grant dip coolers are to be used, fit them to the bridge plate as shown:
2.2.2 Bath controller - stainless steel tank S5
Fit the controller through the smaller of the two cut outs in the bridge plate with
the front of the controller facing over the larger cut out. Using the three M3
screws supplied, fit the controller to the bridge plate. With the plate correctly
aligned with the controller, three holes in the plate line up with three screw
fixings in the base of the controller. Fit the lip of the bridge plate into the gap
between the cut out in the plastic case and the tank in the front of the bath
such that the lip of the bridge plate is lodged under the lip of the tank. Fix the
bridge plate to the bath using the M5 screw, this goes through hole in the rear
of the bridge plate and screws into the screw fixing in the case.
17090 Version 15 - June 2009 83S
Page 5
1
3
www.grant.co.uk
2
4
GD100, GD120
Operating Manual