Ironing Recommendations; Use - MAXXMEE 08048 Mode D'emploi

EN

IRONING RECOMMENDATIONS

• Check before ironing whether the garment which is to be ironed has a label with
ironing instructions on it and follow them. Otherwise select the ironing temperature
based on the type of fabric. The recommended temperature and steam settings
are:
Label
Synthetics (e.g. nylon, viscose)
Silk
Wool
Cotton
Linen
Materials which must not be ironed
• With blended fabrics base the temperature setting on the most delicate blended
fibre.
• Sort the textiles based on the ironing temperature and start with the garments
which require the lowest temperature. If the temperature on the device is reduced,
wait a short while until the bottom of the iron has cooled down and then continue
ironing.
• Iron delicate textiles inside out.

USE

Please Note!
■
If there are water residues in the water
tank, rinse it out with fresh water and
activate the steam production until all
the water evaporates (see the "Use"
chapter – "Filling the Water Tank" and
"After Use").
■
Before the iron is used on an item of
clothing for the first time, iron over a
damp scrap piece of fabric to remove
any possible production residues from
the bottom of the iron.
For steam-ironing, the water tank (8)
needs to be filled with water. This is not
necessary for dry-ironing.
18
Material Temperature
•
••
•••
MAX
Filling the Water Tank
Please Note!
■
Do not overfill the water tank! Do
not exceed the MAX marking on the
water tank.
■
Never pour additives into the water
tank. These could damage the device.
1. Make sure that the device is not
connected to the mains power and is
not hot.
2. Flip open the water tank lid (15).
3. Use the measuring cup (3) to pour tap
water or distilled water into the filler
opening of the water tank (8).
4. Flip the water tank lid shut.
Steam
No steam
Small amount of
steam
Medium amount
of steam
Lots of steam