Implementation - Functional Characteristics; Reference Conditions - PCE Instruments F 09 Notice De Fonctionnement

MAX Indicates the display of a maximum value in
MIN/MAX mode
MIN Indicates the display of a minimum value in
MIN/MAX mode
OK Symbol which goes on during the phase rotation
direction detection sequence.
PF Goes on steady, for switch position W, if power
factor display is selected (yellow key)
AC Fixed: measurement in AC manual mode
Flashing: measurement in AC automatic mode
DC Fixed: measurement in DC manual mode
Flashing: measurement in DC automatic mode
: Semi-conductor test on position Ω Ω Ω Ω Ω
3∅ ∅ ∅ ∅ ∅
Power measurement on balanced 3 phases
system.
I I I I I The Buzzer
Different tones are emitted according to the function given
to the buzzer :
- Short and medium sound: valid key
- Short and high-pitched sound: prohibited key
- Short and low sound: Quit MIN/MAX mode
- 2 short and high-pitched beeps: validation of a
configuration parameter
- Short and medium sound every 400 ms: voltage
measured higher than the unit's guaranteed safety
voltage.
- 5 short and medium recurring beeps: automatic
deactivation of the instrument
- Short and medium sound:
measured continuity value, lower than programmed
threshold, short-circuit junction during semi-conductor
test.
- Modulated medium continuous sound: value
measured in volts, higher than 45 V peak when the V-
Live function is selected.
3. IMPLEMENTATION
FUNCTIONAL CHARACTERISTICS

3.1 Reference conditions

The functional characteristics mentioned in each of the
measurement functions are guaranteed in the following
reference ranges:
- Temperature: +23°C ± 3 K
- Humidity: 45% to 75% relative humidity
- Supply voltage: 8.5 V ± 0.5 V
- Frequency range of applied AC signal: 45 -65 Hz
30
30