Maintenance; Changing The Battery; Storage; Cleaning - PCE Instruments F 09 Notice De Fonctionnement

7. MAINTENANCE

For maintenance, use only specified spare parts. The
manufacturer will not be held responsible for any accident
occuring following a repair done other than by its After
Sales Service or approved repairers.

7.1 Changing the battery

The clamp must be disconnected from any external electrical
source and must not be in contact with the cable.
I Set the switch to OFF
I Slide a screwdriver into the slot at the top of the battery
cover (rear of the clamp) and push the battery cover
upwards.
I Replace the used battery by a 9 V battery, type LF22;
observe the polarities.
I Install the battery in its housing, then install the battery
cover.

7.2 Storage

If the clamp is not used for a period of more than 60 days,
remove the battery and store it separately.

7.3 Cleaning

The clamp must be disconnected from any external
electrical source and must not be holding the cable.
I Clean the unit and jaws with a cloth slightly moistened with
soapy water. Clean off with a damp cloth. Then dry quickly
with a cloth or pulsed air.
I Do not splash water onto the clamp.
I Keep the gap between the jaws in a state of perfect
cleanliness.

7.4 Metrological verification

Like all measuring or testing devices, the instrument
must be checked regularly.
This instrument should be checked at least once a year. For
checks and calibrations, contact one of our accredited
metrology laboratories (information and contact details
available on request), at our Chauvin Arnoux subsidiary or
the branch in your country.
Repair
For all repairs before or after expiry of warranty, please
return the device to your distributor.
46
46