Removing And Replacing The Oven Door; Removing And Replacing The Storage Drawer - Samsung FE-R400SX Manuel D'utilisation

REMOVING AND REPLACING THE OVEN DOOR

How to remove the door
• The door is very heavy. Be careful when removing and lifting the door. Do not lift the
CAUTION
• Turn the power OFF before removing the door.
1. Open the door completely.
2. Pull the hinge locks down toward the door frame
to the unlocked position.
3. Firmly grasp both sides of the door at the top.
4. Close the door to the door removal position, which is
approximately 5 degrees from vertical (Fig. 1).
5. Lift door up and out until the hinge arm is clear of the
slot (Fig. 2).
How to replace the door
1. Firmly grasp both sides of the door at the top.
2. With the door at the same angle as the removal position,
slide the indentation of the hinge arm into the bottom edge
of the hinge slot. The notch in the hinge arm must be fully
inserted into the bottom of the slot.
3. Open the door fully. If the door will not open fully, the
indentation is not inserted correctly in the bottom edge of
the slot.
4. Push the hinge locks up against the front frame
of the oven cavity to the locked position.
5. Close the oven door.

REMOVING AND REPLACING THE STORAGE DRAWER

How to remove the storage drawer
1. Pull the drawer out until it stops.
2. Lean the front of the drawer and pull out it until
it stops.
3 Lift and pull the drawer out.
How to replace the storage drawer
1. Put on the drawer side over both hook.
2. Push the drawer until it stops.
3. Lean and lift the drawer.
4. Naturally push the drawer.
37_ Maintaining your appliance
FE-R400_XAC_DG68-00297A-06_EN.indd 37
door by the handle.
Hinge lock
Locked position Locked position Unlocked position Unlocked position
about 5°
Fig. 1 Fig. 1 Fig. 2
Fig. 2
Bottom
edge of slot
Hinge lock
Locked position Locked position Unlocked position Unlocked position
Hook
Hinge arm
Indentation
Hook
2013-06-11 12:38:47