Safety Information; Instructions - AquaScape AQUASURGE 2000-4000 Mode D'emploi

Safety Information

WARNING: Risk of electric shock – This pump
has not been approved for use in swimming
pool or marine areas
WARNING: To provide continued protection
against risk of electric shock, connect to
properly grounded, ground fault circuit
interrupter (GFCI) outlets only, using the
following guidelines:
(A) Have a qualifi ed electrician install a properly
grounded receptacle outlet, acceptable for outdoor
use and protected from snow and rain.
(B) Inspect cord before using.
(C) Do not using extension cords.
(D) Any wiring of pumps should be performed by a
qualifi ed electrician to ensure code compliance and
user safety.
(E) Unplug pump at receptacle outlet when not in use
or before removal from pond.
Installation
• Always operate the pump fully submerged; or if using
in-line ensure a constant source of fresh water. Failure to
do so may overheat the pump and cause it to fail, voiding
the warranty.
• Use only in fully assembled state, paying particular
attention to ensure that both the outer and inner fi lter
screens are attached to the pump. Failure to operate the
pump without the fi lter screen will allow large debris to
enter the pump and cause the pump to fail, voiding the
warranty.
• Do not wear loose clothing that may become entangled in
the impeller or other moving parts.
• Keep clear of suction and discharge openings. DO NOT
insert fi ngers into pump with power connected.
• Do not pump hazardous materials or liquids, such as oil,
saltwater or organic solvents.
• Do not block or restrict discharge.
• Products returned must be cleaned, sanitized, or
decontaminated, as necessary, prior to shipment to ensure
that employees will not be exposed to health hazards in
handling said material. All applicable laws and regulations
shall apply.
4
(F) To reduce risk of electrical shock, all wiring and
junction connections should be made per local
codes. Requirements may vary depending on usage
and location.
(G) The power cable should be protected at all times to
avoid punctures, cuts, bruises and abrasions.
(H) Never handle power cords with wet hands.
(I) Do not remove cord and strain relief. Do not
connect conduit to pump.
(J) Do not use power cable to lift pump.
IMPORTANT: Aquascape, Inc. is not responsible
for losses, injury, or death resulting from a failure
to observe these safety precautions, misuse or
abuse of pumps or equipment.
AquaSurge PRO Specifi cations
®
• Input Voltage: 120V AC
• Input Frequency: 60 Hz
• Submersible pump
• For outdoor or indoor use
• Thermally protected
• This pump has been evaluated for use with water only
• Input Amps & Wattage: See chart on next page
US (866) 877-6637 | CAN (866) 766-3426 | aquascapeinc.com