Briteq BT-STAGEPAR 6in1 Mode D'emploi page 9

ENGLISH
 COLOR WW
 COLOR CW
 RED
 ORANGE
 YELLOW
 GREEN
 CYAN
 BLUE
 PURPLE
 STATIC SET
 Press the ENTER button: the display shows the value (000-255) for RED. (change with ± buttons)
 Press the ENTER button: the display shows the value (000-255) for GREEN. (change with ± buttons)
 Repeat the previous steps for all the other remaining colors until you have the desired color mix.
 Press the ENTER button to confirm
MASTER DIM
Used to set the master dimmer while used as master.
 Press the MODE button until the desired function is showing on the display.
 Press the ENTER button: the values can be changed
 Use DOWN and UP buttons to select the desired level for the master dimmer. (please note that the last
selected static color will be used to set the value)
 Once you have the desired level, press the ENTER button to save it.
Note: the setting of this option has NO effect while the projector is used as SLAVE or in DMX-mode.
WHITE BALANCE
Used to set the white balance or to perfectly match the colors of several projectors.
 Press the MODE button until the desired function is showing on the display.
 Press the ENTER button: the display shows the value (050-255) for RED. (change with ± buttons)
 Press the ENTER button: the display shows the value (050-255) for GREEN. (change with ± buttons)
 Repeat these steps for all the remaining colors until you have the desired white balance.
 Press ENTER to confirm. The settings will be automatically saved.
Note: the setting of this option affects all color settings, static colors and DMX-controlled colors.
DIMMER CURVE
Used to set the dimmer curve of the master dimmer.
 Press the MODE button until the desired function is showing on the display.
 Press the ENTER button: the values can be changed
 Use DOWN and UP buttons to selected the desired curve:
 Once you have the desired curve, press the ENTER button to save it.
LAMP BEHAVIOR
Used to select the reaction time of the projector.
 Press the MODE button until the desired function is showing on the display.
 Press the ENTER button: the values can be changed
 Use DOWN and UP buttons to select the desired mode:
 LED
 HALOGEN
 Once the correct option shows on the display, press the ENTER button to save it.
BRITEQ
®
warm white 3200K
warm white 5600K
this is a color that can be set by the user. Follow these steps:
The projector follows the instructions instantly, no delay.
The projector imitates the behavior of a halogen lamp (slower reaction time).
7/55 LDP-COBWASH 60TC + 150TC
OPERATION MANUAL