Briteq BT-STAGEPAR 6in1 Mode D'emploi page 10

ENGLISH
LOCKING MODE
Used to lock the setup menu against unwanted altering of the settings.
 Press the MODE button until the desired function is showing on the display.
 Press the ENTER button: the values can be changed
 Use DOWN and UP buttons to select the desired mode:
 OFF
The setup menu can be used at any time.
 ON
After a short time the setup menu locks automatically, the display shows " LOCKED ***** ".
Unlock the display by pressing the buttons in this order: UP, DOWN, UP, DOWN, ENTER.
 Once the correct option shows on the display, press the ENTER button to save it.
NO DMX BEHAVIOR
Used to set how the projector reacts when the DMX-signal suddenly disappears.
 Press the MODE button until the desired function is showing on the display.
 Press the ENTER button: the values can be changed
 Use DOWN and UP buttons to select the desired mode:
 BLACKOUT
 FREEZE:
 Once the correct option shows on the display, press the ENTER button to save it.
Note: as soon as the input detects a DMX-signal, blackout or freeze mode will be cancelled.
DEFAULT SETTINGS
This is your emergency exit if you really messed up the settings: just return to factory settings.
Also 2 user settings can be saved/loaded.
 Press the MODE button until the desired function is showing on the display.
 Press the ENTER button: the values can be changed
 Use DOWN and UP buttons to selected the desired settings:
 FACTORY
 USER1
 USER2
 Press the ENTER button:
 FACTORY was selected: the display shows "LOAD"
 Press the ENTER button: the display shows "CONFIRM?"
 Use DOWN and UP buttons to select YES / NO
 Press the ENTER button to confirm.
 USER1 / USER2 was selected: the display shows "ACTION?"
 Use DOWN and UP buttons to select LOAD / SAVE
 Press the ENTER button to confirm: the display shows "CONFIRM?"
 Use DOWN and UP buttons to select YES / NO
 Press the ENTER button to confirm.
 SAVE was selected: the current settings of the setup menu are saved to memory.
 LOAD was selected: the previously saved settings are loaded.
FIRMWARE VERSION
Used to show the current version of the firmware.
 Press the MODE button until the FIRMWARE is showing on the display.
The firmware of this unit can be upgraded using a special upgrade tool with Windows
available from Briteq).
Each time the projector is switched on, the display shows "UPDATE Wait ....": while this message shows on
the display you can start the update using our special upgrade tool. More information about this can be found
in the user manual of the upgrade tool and / or our website: www.briteq-lighting.com
BRITEQ
®
output turns black while no DMX is detected.
output based on the last valid DMX-signal is kept on the projector.
8/55 LDP-COBWASH 60TC + 150TC
OPERATION MANUAL
®
software. (separately