Required Tools; Power Supply - Eaton xChargeIn A Serie Manuel D'installation

Connections and wiring
7.2

Required tools

The following tools are required for the electrical installation:
●
●
●
●
●
7.3

Power supply

The power supply (supply line) must be hardwired to an existing domestic in-
stallation and comply with the applicable national regulations.
Mains disconnector
The charging station does not have its own power switch. The line circuit
breaker of the supply line serves as a mains disconnector.
Selection of RCD / fault-current circuit breaker
Each charging station must be connected via a separate RCD (Residual
Current Device / fault-current circuit breaker). No other consumers may be
connected to this circuit.
An RCD with at least Type A must be used since all xChargeIn variants have
an internal DC fault current monitoring ≥ 6 mA.
During installation, other important issues such as "cascading" of RCD and
selection of a suitable line circuit breaker must be considered.
Dimensioning of the line circuit breaker
When dimensioning the line circuit breaker, the increased ambient tempera-
tures in the control cabinet must also be taken into account! Under certain
circumstances, this can make a reduction of the charging current specifica-
tion necessary in order to increase the system availability.
The nominal current must be determined in accordance with the type plate
data in coordination with the desired charging power (DIP switch settings for
charging current specification) and the supply line.
I
(DIP switch)
30
Flathead screwdriver for supply terminals (blade width 5.5 mm)
Flathead screwdriver for terminals X1/X2 (blade width 3.0 mm)
Phillips head screwdriver PH2
Mounting tools for cable screw connections M16 (width across flats 20
mm) and M32 (width across flats 36 mm)
®
LSA+ insertion tool (optional)
≤ I ≤ I
(circuit breaker) (supply line)
≤ I
(nominal current)
xChargeIn
Installation manual V1.01
© EATON