Eaton xChargeIn A Serie Manuel D'installation page 206

xChargeIn
Variants with energy meter / MID
Variants with the option "energy meter, not calibrated" may be used for en-
ergy measurement and evaluation of self-energy consumption. Due to the
lack of proof of accuracy, these devices must not be used billing energy.
Variants with the option "calibratable energy meter, MID" are authorized for
the measurement of active energy for billing purposes (according to MID
2014/32/EU). These devices are specially marked on the type plate (MID ap-
proval). The associated type examination refers to the complete unit. The
measurement of the transmitted energy takes place by means of transduc-
ers on all phases to be contacted. Further documents concerning MID (e.g.
test mode) can be requested from Eaton.
Not all variants deriving from the product designation are available with cali-
bratable energy meter (MID). A list of possible variants is included in the type
examination certificate.
Information
None of the functions and settings accessible when the connection panel
cover is open (e.g. DIP-switch setting) will affect the operation or accuracy
of the electricity meter. A seal of the terminal cover is thus sufficient for
tamper protection by third parties. It is not possible to switch the contactor
(charge enable) without active energy measurement.
Variant for Z.E.-Ready / E.V.-Ready
The certifications Z.E. Ready and E.V. Ready describe the compatibility of
the charging station and the installation of the complete system according to
specific Renault or Renault-Nissan standards.
For more information about these devices and related training, please con-
tact Eaton via the online contact form or your assigned supervisor.
Installation manual V1.01
© EATON
Description of the charging station
19