Eaton xChargeIn A Serie Manuel D'installation page 211

Mounting and installation instructions
●
●
●
●
●
●
●
●
Observe the internationally valid installation standards (e.g. IEC 60364-1
and IEC 60364-5-52) and comply with the nationally applicable installation
standards and regulations.
24
Mount the charging station so that it is not located in the direct flow of
passersby and so that no one can trip over connected charging cables
and so that the charging cables do not cover or cross passing pedestrian
and motorized traffic.
Do not install the charging station at locations where it is exposed to am-
monia or ammonia gas (e.g. in or at stables).
The mounting surface must be sufficiently stable in order to withstand
the mechanical forces.
Do not install the charging station at locations where falling objects could
damage the device (e.g. hung up ladders or automobile tires).
The device must not be exposed to direct spray water (e.g. neighboring
manual car wash facility, high-pressure cleaner, garden hose).
The device should be protected against direct rain as far as possible to
prevent icing, hail damage or similar.
If possible, the device should be mounted protected from direct sunlight.
Otherwise, (e.g. set up outside at a parking space) the charging current
specification will be reduced to 16 A if the maximum permitted tempera-
ture is exceeded. The charging process can also subsequently be
switched off.
Observe the permissible environmental conditions (see "Technical
data").
xChargeIn
Installation manual V1.01
© EATON